REPORT COPYRIGHT VIOLATION IN MESSAGE
|
Subject
|
Question for you electronic/circuit builders
|
Poster Handle
|
-Adam- |
Post Content
|
Is there any way to separate or filter out a sawtooth wave dependent upon which direction the saw tooth edge is?
ie, one part lead rises sharp and tapers for one signal and the other signal has a leading taper then a sharp drop in voltage.
I do not want to filter frequency, already have a passive low pass to cut high freq noise.
Just need to separate the two signals. (or omit one and then buffer, omit the other)
I am completely baffled on this one.
|
|
Please verify you're human:
|
|
Reason for copyright violation:
|