Ionic / Colloidal silver at home.

This guy is on here frequently and would probably be able to help you. This link is for his thread on making it at home.

Thread: How I make Colloidal Silver for personal use

Colloidal Silver Recipe

Note: Before ingesting or injecting silver, test
some on the back of your hand to ensure you are
not allergic to the silver. Very few people are
but it pays to test, especially if you've never
worn silver jewelry.

Ingredients

1. Silver, the purer the better, within reason.
DO NOT use Sterling Silver! This has nickle
added to it for strength ~ nickle is very toxic!
(Stainless steel has nickle too!) A 200mm (8inch)
length of 99.9% pure silver wire about 3mm/one
eighth inch diameter isn't that expensive and is
perfect for this purpose. See your local jeweller,
not your pharmacist, for this 'medicinal' substance!

2. Pure, distilled water. Not filtered, not spring
and certainly not salty water. It must be distilled!
The same water you should be using to top up your
car's battery.

3. A clean, DRY glass jar with a plastic lid/cover.

4. 2 or 3 9V battery's the 'square' type. These
do NOT need to be brand new as we only need milli-
watts. 2 new ones or 3 older ones or a mix - it's
not critical what voltage you use but about 25-30V
is ideal. These need to be connected in series which
is positive of one to the negative of the next and
they can simply be 'plugged' onto each other.

5. Clips for the above.

6. A heat, bubbling, stirring source. I put my jar
in a saucepan of hot, barely simmering water on the
stove. This simply keeps the liquid in motion
otherwise the silver particles will 'congregate'
around your wires/electrodes.

7. A section of 'chocky' block we call it here.
That plastic electrical connecting strip for
joining wires with screws in it... sparky's use
it regularly and we only need two.

8. A screw to go through 'chocky' block mounting
hole.

9. A dark brown or blue glass bottle for storing
your medicine. Silver is light sensitive so this
is critical to prolonging your medicines usefulness.
Properly stored, your medicine should be useful
for EVER!

10. If you're really fussy or unable to check your
CS generator regularly, a limiting resistor
placed in series with your batteries may be useful
~ ideally you do not want the current flow to exceed
about 50mA. If you're watching the process closely
this is unnecessary.

11. A cheap laser is useful for confirming the
presence of CS, especially if buying it from
another source.

12. A 'scotchbrite' or some steel wool.

Method

Mount your section of 'chocky' block on top of
your jars lid and poke the silver wires through
the plastic. They should be kept about 1cm apart
and reasonably straight. Heat up a wire and push
it through the plastic.

[link to s1190.photobucket.com]

The above image is looking down on the apparatus,
the below image is looking side on to the apparatus.

[link to s1190.photobucket.com]

Connect your 9V battery clips black to red and
connect the black and red remaining ends to the
'chocky' block. It doesn't matter which way
around they go.

Near fill the jar with distilled water. Do not
do this in direct sunlight or in a brightly lit
room. It doesn't have to be totally dark but too
much light will quickly oxidize the silver and it's
effectiveness will be compromised.

Once the silver is submerged by screwing the lid on,
the reaction will start immediately. You wont be able
to see anything initially but tiny particles of silver
are being 'pulled' or 'sintered' into the water. I've
read that these initial particles are so small that
they can pass between the molecules in a pane of glass!
Hence silver is one of the only known anti-biotics
capable of crossing the blood-brain barrier.

As the silver level increases in the water, the current
flow will increase as well. As the current becomes
stronger, the size of the silver particles also increases.
It's important not to let the solution remain 'stagnant',
otherwise the silver will crowd around the electrodes. I
use a saucepan of hot water - just below simmering level.
Sitting the jar in this ensures the water is constantly
convected around the inside.

Eventually you will see some tiny bubbles coming off one
electrode and one of the electrodes will start to tarnish.
If you have a laser and shine it into the distilled water
you will not see the beam. Once there's sufficient silver
suspended in the solution, the beam will reflect off the
particles and become visible ~ great method for checking
a product if you're buying it.

Towards the end of the process some grey 'sludge' will
also accumulate on one of the wires. Unscrew the top
and use a tissue to wipe the sludge off.

As soon as the solution starts to 'yellow', stop the
process. Let your solution cool before storing it in
the dark glass bottle. Use the scotchbrite or steel wool
to clean the electrodes and stow your 'medicine maker'.
A 200ml jar should take about 40 minutes to make using
3 9V batteries, with 2 batteries it will take over an hour.

Store your CS in a cool, dark place but not the fridge.
It should be kept away from strong magnetic fields so
keep it away from micro-waves, speakers, CRT's, etc.

You should end up with a bright, clear yellow solution
which will be about 15-18ppm of one of the most versatile,
gentle yet powerful and totally safe anti-biotics known
to man .You can inject it intraveinously, it's safe for
pregnant women and babies.

The yellow is apparently related to the size of the particles
~ they only reflect the yellow wavelength. It is theorized
that the silver disables the oxygen metabolizing enzyme
used by anaerobic bacteria, thus they're very quickly
'suffocated', have no chance to breed and hence can never
develop a resistance either. Large dosing on silver can
deplete the gut of some intestinal flora so topping up
on yoghurt or acidophillus will help restore any imbalance.

I have read that 2 French medical research institutions have
tested CS and found that in the 4 days prior to the full
moon, it's anti-biotic properties can be reversed! I have had
customers report an exacerbation of their conditions when
inadvertantly using CS during this period so I advise all my
customers to abstain from using it during this time.

Silver was called "Luna" by alchemists ~ perhaps they knew of
an association? Greeks and Romans lined their bowls and goblets
(the wealthy ones anyway) with silver so I'm sure they were
aware of it's food-prolonging abilities which American
pioneers also exploited by putting a silver dollar in their
milk before refridgeration.

Tips for Using CS

Little and often is the key.

When taking internally, hold it in your mouth and swish
it all around. Up to 90% of the solution can be ingested
via sublingual absorption in this manner. Swallowing it
straight away will not hurt you but it won't do you as
much good either as you will be lucky to absorb 30% of it.

Keep it next to your bed at night,
if you hold it in your mouth when
you're thirsty, you will absorb it
very efficiently.

Use a plastic or wooden spoon ~ not metal.

It's a good idea, especially if dealing with a systemic
condition, to really chow down on the HOTTEST chilli you
can immediately after dosing up on CS. This will greatly
help 'deliver' the CS to the entire body. Read Dr Schultz's
"Curing with Cayenne" ~ it really deserves it's own thread
but he speaks of having patients in his waiting room
suffering a stroke. He pours them a cup of cayenne 'tea'
and they often walk out after half an hour! Great stuff!

A dark glass bottle with a spray nozzle is really handy
for applying CS topically. Be as liberal as you like ~
if you 'over-cook' the brew slightly (it goes brownish
if left on too long) don't throw it out! Put it in the
spray bottle for using topically.

If using it for an eye condition (it's awesome on
'pinkeye'), put it in an eye-dropper bottle and add 1/2
teaspoon salt per 25ml. The salt will totally stop it
stinging when it contacts your eye.

Kia Kaha!

I really should turn myself in now, eh?

You bet!

A friend of mine and I are going to split the cost on one of these sets.

[link to www.goldismoney2.com (secure)]

The thread’s purpose was, and remains, an effort to provide accurate, honest, and non-commercial information to those interested in making the most effective form of colloidal Silver.
The biggest problem with colloidal Silver is its name. If we call something colloidal, it merely means that it is held in suspension. For example, milk is colloidal butterfat. As it is homogenized, the fat particles will tend to stay in suspension because the particles have been agitated to the point where they are small enough to not combine and rise to the top.
Now, what does this have to do with making colloidal Silver? It’s not hard to understand why we want the smallest possible particles of Silver. Let’s face it. We don’t want any more metal of any kind in our body other than what we need to stay well or heal a wound or infection. For a given total weight of the metal, small particles will result in a much greater surface area than large particles. For Silver to affect the microbe, it has to come into contact with that microbe. For the sake of simplicity, let’s consider our particles as spheres. If our particle is 100 nm in diameter, it will weigh the same as about 10,000 1 nm particles. What would have a better chance of getting to the bacteria we want to kill? 10,000 or one?
“Colloidal silver” is sold with ratings of parts per million “PPM.” That is the ratio of the water’s weight versus the Silver contained and suspended in the water. This measurement is made by the method of atomic absorption spectrophotometer. A sample is burned, and the light emitted includes spectral lines for Silver, the amplitude of which gives an indication of the parts per million, by weight. There is nothing in this method to distinguish between ions, “charged” particles, and uncharged.
It is easy for an unscrupulous colloidal Silver manufacturer to make and advertise “colloidal silver” with strengths of 20, 30, 50, or 500 PPM. All they have to do is generate large particles and coat them with a substance lighter than water to stay in suspension. These solutions will have a color as the larger particles will block out portions of the ambient light, trying to shine through the water. The larger the particles, the more color, beginning with light yellow. There is real evidence to suggest that these solutions will do you harm, leading to a condition called argyria.
As you read through the thread, you will find numerous citations of serious, peer-reviewed studies illustrating silver ions’ superiority in killing bacteria to silver particles. The number of silver ions is measured in terms of electrical conductivity. When this thread started, the only instruments with the ability to measure this were quite expensive. The price of these has come down to a remarkable degree. A device capable of measuring ionic PPM within one or two ppm is now available on eBay for less than $10. If you’re going to make colloidal silver “ionic,” one of these should be the first thing you purchase. The second thing is to make sure that you get genuine 9999 pure silver wire with a certificate of analysis from a reputable source. Other than that, all you need is a voltage source and a resistor to limit the current. A multimeter with the 2 V scale and an additional 1K resistor will allow you to measure your current in microamps. That is all you need to make perfect, clear colloidal Silver. With a certain amount of experimentation, you will be able to make your colloidal Silver of a quality equal to commercial manufacturers’ offerings.

Why the fuck are you spamming every damn cs-thread ?