Godlike Productions - Discussion Forum
Users Online Now: 1,604 (Who's On?)Visitors Today: 118,818
Pageviews Today: 207,713Threads Today: 65Posts Today: 1,342
02:46 AM


Back to Forum
Back to Forum
Back to Thread
Back to Thread
REPORT ABUSIVE REPLY
Message Subject How to use Colloidal Silver as Medicine
Poster Handle abeland1
Post Content
[link to theartofmakingcolloidalsilver.com (secure)]

To check if we are done with the process, place your finger on the generator and gently move the position of the wires, as shown in the picture above. Observe the change, if any, in the brightness of the LED. If the LED dims noticeably when we moved the wires in the water, we are not finished.
It is important to gently move the position of your generator the when you see the red LED glowing brighter during the process.
https://imgur.com/a/aPHouge

In this picture we can see that the LED is much less bright after we have moved the position of the silver wires.
https://imgur.com/a/ZjlnDAK

This is confirmed by measuring the PPM of the water in the glass. It reads slightly over
two PPM. So we continue the process.
https://imgur.com/a/JfyKRdo

We are now 3 hours into the process, our conductivity meter reads 5 PPM, and we
continue the process.
https://imgur.com/a/CTa6STN

We are now five hours into the process and we can see that the LED is once again at full brightness. At this time, we will once again do the finger test. We observe that the LED’s brightness remains the same when we press on the generator. This means that we have achieved well over 10 PPM strength of colloidal silver. Please note that your process could be less than 5 hours depending on the quality of your distilled water.
https://imgur.com/a/1dBuEB3

We confirm this with the use of our electrical conductivity meter. It reads 15.1 PPM.
Please note that the reading will vary depending on the quality of your distilled water.
We are now finished with the process of making our colloidal silver.
https://imgur.com/a/b45LSRV

Remove the generator from the water and clean the silver wire with a green scouring pad supplied. Two or three swipes should be sufficient.
https://imgur.com/a/Cnlul5f

We now use our red laser pointer included with the kit to confirm the fact that we have made actual particles as well as the ions that are measured by an electrical conductivity meter. If we include the particles in our measurement, which are not shown by conductivity, the true PPM would be 17 to 18 in parts per 1,000,000.

In the days before good laser pointers were available; the only way we had to ensure that we had made larger particles was for the water to turn yellow. You will find many people who still believe that Colloidal Silver should be yellow because of this. The fact is that a yellow color Colloidal Silver indicates particles over 40 nanometers in size. Clear color, like water, means smaller particles. Small particles are better. Some people refer to silver particles this small as nanosilver.
Filter the colloidal silver to remove any large particles that may have formed. A coffee maker filter of the unbleached variety is perfect for this.
We now have 12 ounces of better colloidal silver than can be purchased at a store. We can do this hundreds of times before we have to buy more silver wire.
 
Please verify you're human:




Reason for reporting:







GLP