Godlike Productions - Discussion Forum
Users Online Now: 2,238 (Who's On?)Visitors Today: 957,139
Pageviews Today: 1,707,650Threads Today: 728Posts Today: 12,969
07:21 PM


Back to Forum
Back to Forum
Back to Thread
Back to Thread
REPLY TO THREAD
Subject Question for you electronic/circuit builders
User Name
 
 
Font color:  Font:








In accordance with industry accepted best practices we ask that users limit their copy / paste of copyrighted material to the relevant portions of the article you wish to discuss and no more than 50% of the source material, provide a link back to the original article and provide your original comments / criticism in your post with the article.
Original Message Is there any way to separate or filter out a sawtooth wave dependent upon which direction the saw tooth edge is?

ie, one part lead rises sharp and tapers for one signal and the other signal has a leading taper then a sharp drop in voltage.

I do not want to filter frequency, already have a passive low pass to cut high freq noise.

Just need to separate the two signals. (or omit one and then buffer, omit the other)



I am completely baffled on this one.
Pictures (click to insert)
5ahidingiamwithranttomatowtf
bsflagIdol1hfbumpyodayeahsure
banana2burnitafros226rockonredface
pigchefabductwhateverpeacecool2tounge
 | Next Page >>





GLP